Repair Leaky Gates/Gaskets And Eliminate A Set (Save $32.10/acre)

Repair Leaky Gates/Gaskets And Eliminate A Set (Save $32.10/acre)

December 5, 2008

C. Dean Yonts, Extension Irrigation Engineer

Added profit: $32.10/acrea

aBased on elimination of two sets, 12 hr/set, 1000 g/m well, five irrigations/year, $10/ac-in pumped, $1.03/ac/yr to replace gates and gaskets.

Minimizing inefficiencies in gravity irrigation systems can save irrigators money and labor. Normal wear and tear associated with piecing together sections of irrigation pipe and opening and shutting gates can cause significant inefficiencies to irrigation over time.

Estimating losses. Flow meters provide a method for estimating the amount of water that leaks from gates and gaskets. While leaks are not losses from the field, they do reduce the amount of water delivered to the set being irrigated. A Tri-Basin Natural Resource District study in the early 1990s showed that losses can exceed 50%. Often losses can be 20% to 30%, which is 5 to 6 gallons/minute per 30-foot length of pipe on most systems. A quarter mile length of pipe on a 1000 gallon/minute well would deliver only 750 gallons/minute to the set if the water loss is 25%.

Saving water. The impact of losing 250 gallons/minute is shown in Table 1 (below). The example simplifies calculations by using average set size, although number of gates per set is generally variable. It also assumes potential flow rate to be equal at both ends of the line, although actual field results will be different, depending on which set of gates are open, system design and relative elevation from one end to another.

Saving labor. Reducing leaks has added benefits that are not included in the suggested "added profit." Labor is an obvious major savings associated with fewer sets per irrigation. We did not assign a value to labor, so you can use your own numbers on eliminating two trips to the field and the time associated with setting gates and checking rows.

Improving water quality. Another benefit can be improved ground water quality. Severe leakage can add a constant supply of water to one area for the duration of the irrigation. On silt-loam soils, one gallon per minute running down a row will only advance about 100 feet. If that loss were to occur uniformly along the pipeline, it would amount to about three acres along the pipe. If 250 gallons/minute in leaks run for 3 days, 40 ac-in per irrigation will be applied to about 3 acres of cropland. Estimates suggest that 5 pounds of nitrate move with every inch of water that leaches below the root zone (Watts). Continuous leaking has the potential to flush hundreds of pounds of nitrogen into the aquifer. Aside from contamination of the aquifer, it would take excess nitrogen to offset the loss, or acceptance of fewer bushels produced from those three acres.


  • Flag leaky gaskets and mark leaky gates during the year to ensure repairs can be made in the off-season.
  • Discard gaskets where flagged, as you pick up pipe at the end of the season. Some people carry gates with them and change damaged gates when they are found during the year. If that doesn't work for you, mark your calendar to replace gates after harvest.

A little labor in the off season can pay big dividends when things get hot and heavy during the summer.


The Impact of Nitrogen and Irrigation Management and Vadose Zone Conditions on Ground Water Contamination by Nitrate-Nitrogen, Darrell Watts, University of Nebraska–Lincoln Extension Circular EC 91-735.


We would like to acknowledge the contributions of Andrew Christiansen, who wrote the first edition of this publication.

Table 1a. Number of irrigation sets based on leakage of 250 and 50 gpm. Assumptions include that the field is 80 acres, has 1/4 mile rows, and irrigation is every other row.
GPM Leaking
Well Output
GPM per Irrigated Furrow
Total Rows
Rows Per Irrigation Set
Number of Irrigation Sets Needed
Table 1b. Dollars saved by reducing number of irrigation sets from 11 to 9, assuming five irrigations per year.
Set Time
Hours Pumped/Irrigation
Hours Pumped
Per Year1
Ac-in Pumped
Per Year
Cost2 at $10/ac-in
Pumping Cost Per Acre
Cost of Repairs
Per Acre3
Dollars Saved4
1Assuming five irrigations per year.
2Includes fuel, lube, maintenance, depreciation. A wide range of values exists depending on whether the system is electric, diesel, propane or natural gas and depth to groundwater. A cost of $10.00 is used in this example for fuel and lube for pumping 1 ac-in of water.
3Includes 4 gaskets @ $5.00/gasket, 69 gates @ $.90/gate in 2640 feet of pipe, 80 ac.
4Dollars saved: $182.25 - $149.12 - $1.03 = $32.10

Online Master of Science in Agronomy

With a focus on industry applications and research, the online program is designed with maximum flexibility for today's working professionals.

A field of corn.