Planting Wheat into Dry Soils

Planting Wheat into Dry Soils

Sept. 9, 2011

Although late summer precipitation has generally been better this year than last year, there are areas in western Nebraska that still have very dry surface soil conditions. With the optimum wheat seeding time upon us in the far west and rapidly approaching further east, many wheat growers are remembering last year's poor wheat stands and wondering what the best strategy may be if rain continues to be scarce. In the following article Jim Shroyer, extension agronomy state leader, and Loyd Stone, soil and water management specialist, both at Kansas State University, discuss the pros and cons of several possible seeding strategies for this situation. — Drew Lyon, UNL extension dryland crops specialist

Soils are generally very dry in much of Kansas, especially western and southern areas. Producers faced with very dry soils basically have three main options:

Spotty wheat stand, western Nebraska
Wheat planted into dry soils last fall (2010) resulted in spotty stands in areas of western Nebraska.

1.  Dust it in at the normal seeding depth and normal planting date -- and hope for rain. This is probably the best option. The seed will remain viable in the soil until it gets enough moisture. Before planting, producers should look at the long-term forecast and try to estimate how long the dry conditions will persist. If it looks like there’s a good chance the dry weather will continue until at least the back end of the optimum range of planting dates, producers should treat the fields as if they were planting later than the optimum time. Rather than cutting back on seeding rates and fertilizer to save money on a lost cause, producers should increase seeding rates, consider using a fungicide seed treatment, and consider using a starter fertilizer. The idea is to make sure the wheat gets off to a good start and will have enough heads to have good yield potential, assuming it will eventually rain and the crop will emerge late. Wheat that emerges in November almost always has fewer fall tillers than wheat that emerges in September or October.

There are some risks to this option. For one thing, a hard rain could crust over the soil or wash soil off planting ridges and into the seed furrows, potentially causing emergence problems. Another factor is the potential for wind erosion is the field lies unprotected with no ridges. Also, the wheat may not come up until spring, in which case it may have been better not to plant the wheat at all and plant a spring crop instead. Probably the worst-case scenario for this option would be if a light rain occurs and the seed gets just enough moisture to germinate the seed but not enough for the seedlings to emerge through the soil or to survive very long if dry conditions return. This could result in a loss of the stand.

2.  Use a hoe drill to plant deeper than normal into moisture now, if possible. This option can work if the variety to be planted has a long coleoptile, the producer is using a hoe drill, and there is good moisture within reach. The advantage of this option is that the crop should come up and make a stand during the optimum time in the fall. This would keep the soil from blowing. Also, the ridges created by hoe drills also help keep the soil from blowing.

The main risk of this option is poor emergence. Deep-planted wheat normally has below-normal emergence, so a higher seeding rate should be used. Any rain that occurs before the seedlings have emerged could add additional soil into the seed furrow, making it even harder for the coleoptile to reach the soil surface. Any time you increase the seeding depth, the seedling will have to stay within the soil just that much longer before emerging through the soil surface. Delayed emergence leads to more potential for disease and pest problems, and reduced tillering potential late in the season. It’s even possible that the wheat would get planted so deep that it would germinate but never emerge at all, especially if the coleoptile length is too short for the depth of planting. Generally speaking, it’s best to plant no deeper than 3 inches with most varieties.

3. Wait for a rain, and then plant. To overcome the risk of crusting or stand failure, producers may decide to wait until it has rained and soil moisture conditions are adequate before planting. Under the right conditions, this would result in good stands, assuming the producer uses a high seeding rate and a starter fertilizer, if appropriate. If it remains dry well past the optimum range of planting dates, the producer would then have the option of just keeping the wheat seed in the shed until next fall and planting spring crop next year instead.

The risk of this option is that the weather may turn rainy and stay wet later this fall, preventing the producer from planting the wheat at all while those who “dusted” their wheat in have a good stand. There is also the risk of leaving the soil unprotected from the wind through the winter until the spring crop is planted.

Crop insurance considerations and deadlines will play a role in these decisions.

There has been some talk about whether soil moisture can move upward in the soil as the weather gets cooler, and whether this alone might provide enough moisture in the soil surface for wheat to germinate. While it’s true that a small amount of soil moisture will gradually migrate a bit toward cooler areas of the soil, there is no chance that enough moisture will move upward into the seed zone to germinate wheat simply because the temperature at the soil surface has cooled. Where soils are dry, it will take rainfall for wheat to germinate and emerge.

Jim Shroyer, Extension Agronomy State Leader
Loyd Stone, Soil and Water Management
Both at Kansas State University


Online Master of Science in Agronomy

With a focus on industry applications and research, the online program is designed with maximum flexibility for today's working professionals.

A field of corn.