Post-Harvest Weed Control in Winter Wheat

Post-Harvest Weed Control in Winter Wheat

Good seeding conditions in most areas in the fall of 2016 resulted in good winter wheat stands enabling the winter wheat to be more competitive with weeds (Figure 1).

Timely control of weeds following winter wheat harvest can limit soil moisture loss to weeds and prevent the deposit of more weed seeds in the soil, two factors that can benefit the next crop's yield. In addition, timely control of volunteer wheat is essential in reducing the spread of wheat streak mosaic disease.

In addition to hail causing early volunteer winter wheat, dormancy can also be reduced by higher temperatures during the later stages of the grain fill period. Normally, the grain fill period is 25 days or less, but it can exceed 35 days under good environmental conditions. Any temperature over 85° can reduce wheat yield potential. Therefore, if higher temperatures occurred during the later stages of grain fill, the dormancy period will be shortened and control of volunteer may be needed sooner after harvest.

Winter wheat plots near McCook
Figure 1. Red Willow County Wheat Variety Plot near McCook.

The effectiveness of post harvest weed control is influenced by how competitive the winter wheat crop was and production practices used with the previous wheat crop, such as

  • winter wheat variety selection,
  • fertilizer practices,
  • row spacing,
  • planting date,
  • seeding rate, and
  • weed control in the growing wheat.

Other factors include:

  • weed size,
  • cutting off weed tops with the combine,
  • crop rotation,
  • residue management,
  • temperature when spraying,
  • rain the day of spraying,
  • weed seed distribution, and
  • streaks caused by sprayers, terraces, dust, straw, and chaff.
Graph showing effect of wheat residue
Figure 2. The effect of winter wheat crop residue levels on weeds in corn following winter wheat treated with herbicides post harvest. In general, 1 bushel of wheat produces 100 pounds of crop residue or 60 bushels of winter wheat equals 6,000 lb of crop residue.

Timing

Weeds under stress are difficult to control. Kochia and Russian thistle are day-length sensitive and will begin to flower toward the end of July and into August. It's a general rule that you can wait up to 30 days after harvest to spray wheat grown as part of a three-year rotation. If the wheat was planted without an 11- to 14-month fallow period, spray it within 15 days of harvest. Examine each field separately and adjust your treatment schedule accordingly. This year some fields will need to be sprayed before 15-30 days because of the less competitive winter wheat stands and higher precipitation amounts. The key is to prevent weeds from using soil water and producing weed seeds.

As with all weed control, it's essential that you closely watch for weed developments and spray at the proper time noted on the label to achieve maximum control. Most labels state that weeds must be treated before they are 6 inches tall. If weeds are under severe drought stress, wait for rain and spray about a week later.

Examine each field separately and adjust your treatment schedule accordingly. This year some fields will need to be sprayed in the first one to two weeks after harvest because of the less competitive winter wheat stands and higher precipitation amounts.

Controlling weeds in the growing wheat offers the best chance of reducing weed population and vigor after harvest.

Split Treatments

Split treatments, which have a good history of effectiveness, should be especially beneficial this year.

In Kansas, research has shown a 20-bushel increase in corn yields the next year for treatments applied in July vs. mid-August. When using a split treatment, apply the glyphosate products with companion herbicides (adding surfactant, if needed, plus ammonium sulfate) as the first application in July or early August. Some glyphosate products include sufficient surfactant while many products require more. Be sure to check the product label.

For all glyphosate brands, add ammonium sulfate (spray grade) at 17 lb per 100 gallons of spray solution. (The ammonium sulfate is the first item put into the spray tank after the water.) Ammonium sulfate is especially helpful when stress conditions are present. Liquid ammonium sulfate, with or without a drift retardant, also is available. It's difficult to recognize weed stress so it's wise to always add ammonium sulfate.

As wheat harvest is progressing well across much of the state, this would be a good year to use split herbicide treatments for timely management of post harvest weeds in wheat. Consider making the first post-harvest application between mid-July and early August. The second part of the treatment can be applied in September.

Improve control by increasing the rate of glyphosate. Allow at least six hours — and longer with some weeds — for the glyphosate product to become rainfast. Barnyardgrass may require 24 hours without rain for maximum control. With glyphosates, use a spray volume of 5 to 10 gallons per acre and don't apply when temperatures reach or exceed 95°F.

Producers should control weeds in wheat stubble fields by applying the full label rate of glyphosate with 2,4-D or dicamba to the glyphosate unless susceptible crops or other sensitive vegetation are in the area. Other herbicides that may be added to glyphosate include Spartan, Charge, Authority MTZ, Valor, and Sharpen. Tank mixes with glyphosate will help control weeds that are difficult to control with glyphosate alone and will help reduce the chances of developing glyphosate-tolerant weed populations. Always check labels and rotation restrictions.

If temperatures are above 80°F, use the amine formulation of 2,4-D and dicamba. Do not use 2,4-D or dicamba if sensitive crops or other vegetation may be affected. For additional information, treatments, and rates go to the Ecofarming Section of the 2017 Guide for Weed Management, EC130, (http://marketplace.unl.edu/extension/extpubs/ec130.html).

The second part of the split treatment should be applied in September. It should contain at least 0.5 lb per acre of atrazine and possibly Gramoxone Inteon (add surfactant), depending on the amount and size of volunteer winter wheat, downy brome, jointed goatgrass, or other weeds present.

Effective Cultural Practices to Aid Weed Control

Many options besides increasing herbicide rates are available for weed control after wheat harvest. Vigorous winter wheat stands will compete better with weeds. To achieve maximum control:

  • Prepare a good firm seedbed.
  • Control weeds in a timely manner.
  • Fertilize if needed.
  • Seed properly.
  • Plant at the optimum time.
  • Select a competitive winter hardy winter wheat variety.

Weed Challenges

Several options are available for using nonselective herbicides with difficult-to-control weeds. With Gramoxone Inteon, use a minimum of 2 pints of X 77, or equivalent surfactant, per 100 gallons of solution. Use 2 quarts of X 77 per 100 gallons of spray solution if using less than 20 gallons of carrier. The active ingredient varies among products so check labels and adjust rates accordingly.

The atrazine rate varies with soil and rainfall patterns. In southwest Nebraska, use 2 quarts of atrazine per acre unless the soil or the following crop limits the rate to a lower amount. In the Panhandle the maximum allowed in one season is often 0.5 quart per acre.

  • Volunteer Wheat and Grasses. The advantage of split treatments is that they provide excellent control of volunteer winter wheat and other winter annual grasses. Using one quart or less of atrazine before September 10 allows winter wheat to be planted 12 months later in most areas and soils. If sufficient soil water is available the following spring, corn could be planted or if moisture is limited, the field could be fallowed and winter wheat could be planted in the fall.
     
  • Downy Brome. If downy brome is a problem and a winter wheat fallow rotation is being used, tillage is usually recommended immediately after harvest to plant the seeds and ensure maximum weed germination during the fallow period. Do not till if only a limited amount of crop residue is present after harvest since tillage will make the soil susceptible to wind and water erosion. Herbicides are available to control downy brome in the growing winter wheat and are best applied early. If jointed goatgrass and/or feral rye is a problem, use a rotation where wheat is not planted for at least three years under good moisture conditions and even longer under dry conditions.
     
  • Jointed Goatgrass and Feral Rye. Herbicide-tolerant winter wheat varieties are available for fields with jointed goatgrass or feral rye problems. Beyond™ herbicide is then applied in the growing wheat. (Grower training is required before this herbicide can be purchased.) Check the label for additional information.

Online Master of Science in Agronomy

With a focus on industry applications and research, the online program is designed with maximum flexibility for today's working professionals.

A field of corn.